Product Data Sheet Safety Data Sheet Show all documents
EVERBUILD® 502 Weatherproof Wood Adhesive

EVERBUILD® 502 Weatherproof Wood Adhesive

A high quality, D3, cross linked PVA based wood adhesive.

Can be used internally and externally and provides a high strength, impact resistance bond that is usually stronger than the wood itself. Ideal for all general woodworking and joinery, furniture assembly and household DIY use. Dries clear. Fast cure, initial set in just 10 minutes.

• Excellent rate of bond strength development.
• High degree of water resistance, D3 Classification.   • Interior/exterior use. • Low timber staining characteristics - will not stain.
• Dries clear - contains no inert fillers.
• Water based - environmentally friendly/easy clean up.
• Suitable for radio frequency cure.                                                                                                       Specific Data Viscosity @ 23°C 7000-15000 cP pH 2.0-4.0                                                                                                                       PRODUCT EN204 D3/3 BSEN 14256 Everbuild A/P Wood Adhesive Ave 2.17 N/mm²19.2 daysSpecification≥2.0 N/mm² ≥ 14 days
Product Data Sheet Safety Data Sheet Show all documents

Usage

As a Weatherproof/creep resistant wood adhesive, internally and externally.

Advantages

• Excellent rate of bond strength development.
• High degree of water resistance, D3 Classification.   • Interior/exterior use. • Low timber staining characteristics - will not stain.
• Dries clear - contains no inert fillers.
• Water based - environmentally friendly/easy clean up.
• Suitable for radio frequency cure.                                                                                                       Specific Data Viscosity @ 23°C 7000-15000 cP pH 2.0-4.0                                                                                                                       PRODUCT EN204 D3/3 BSEN 14256 Everbuild A/P Wood Adhesive Ave 2.17 N/mm²19.2 daysSpecification≥2.0 N/mm² ≥ 14 days

Packaging

Bottles: Various sizes up to 1L

Jerry Cans:  5L & 25L

Larger Scale: Drum & IBC

Product Details

Sustainability / Certifications / Approvals

APPROVALS / STANDARDS

D3 Adhesive performance under EN204 / EN205

EN14256 Resistance to static load
Product Information

Shelf Life

12 months

Storage Conditions

To ensure safe storage, containers should be well sealed to prevent evaporation of water and the formation of skin on the surface. It must be stored at a temperature above freezing. A temperature of 5-25°C for not more than six months is recommended. Higher temperatures will affect quality and cause the formation of crusts and skins, especially if the containers are not tightly closed or are subjected to direct sunlight for long periods. During storage, slight separation may occur. (thin layer above thicker layer). This is an aesthetic rather than technical problem. In this case, mix well before applying. If these conditions cannot be met, please refer to our Technical Service Department who will advise on storage stability.

Density

1.0-1.2g/cm3 (dispersion)

Solid content by weight

45-50%
Technical Information

Thermal Resistance

Stable (4 week @ 50°C)

Application

Application steps

APPLICATION INSTRUCTIONS

Apply adhesive thinly to both surfaces. Do not over apply as this will slow down cure. Clamp surfaces together until adhesive dries (off in 1-2 hours: full strength 8 hours). Support until fully cured (8 hours at 20°C). When fitting dowels, the adhesive should be applied to the holes.
• Suitable for radio frequency curing.

SUBSTRATE PREPARATION

All surfaces must be clean, dry and free from grease.

Documents