Need a premium quality waterproofing system? Sikalastic®-560 is your solution. Sikalastic®-560 is a liquid applied, one component roof waterproofing solution. This is ready to use and is cold applied, leaving a seamless finish.
What you will need
- Sikalastic®-560
- Sikalastic® Fleece-120 and Sika® Reemat Premium for detail work around upstands and pipe penetrations
- Large paint brush/ block brush / roller
- Spatula for mixing / mechanical mixer for larger quantities
- Gloves
- Mask (Optional)
Product Information
Step 1: Surface Preparation
Ensure that the substrate is clean, dry and free of all contaminants and correctly prepared. All dust and loose, friable material must be removed. Blow holes and voids should be fully exposed then repaired. Should the substrate be poor or porous, priming of the substrate would be required. Dilute Sikalastic®-560 with 10% water and apply as primer.
Step 2: Apply Bottom Coat
Thoroughly mix the product for 1 minute before applying the primer coat if needed. Once the primer has dried, apply the first coat of Sikalastic®-560.
Step 3: Place Sikalastic® Fleece-120 Membrane
Roll in the Sikalastic® Fleece-120 while the bottom coat is still wet and ensure that there are no bubbles or creases. Overlapping of the fleece must be a minimum of 5 cm.
Step 4: Top Coat
Once the base coat has dried, Sikalastic®-560 can be applied in 1-3 coats depending on service life expectations, allowing each coat to dry before applying the subsequent coat.
SIKA'S TOP TIP
FOR DETAILING AREAS
For complex and detailed roofs the Sika® Reemat Premium should be used.