Sika® RainTite

Water based acrylic

12 months from date of production

The product must be stored properly in original, unopened and undamaged sealed packaging in dry conditions at temperatures between +5 °C
and +30 °C.

±1.17kg/litre

Primer:      1 coat Sika® RainTite

Saturator: 1 coat Sika® RainTite

Top Coat:  1 coat Sika® RainTite

~1.20 mm

+5 °C min. / +35 °C max.

<80%

+5 °C min. / +35 °C max.

Substrate temperature must always be at least 3°C above the measured dew point

<10%

2–3 hours depending upon ambient conditions

~ 2.1 Ltr/m² with membrane

Surface must be clean, sound and properly cured. Remove all loose materials mechanically, preferable with a wire brush. Iron and steel surfaces should be free of rust.

Step 1 Apply a generous base coat of Sika® RainTite waterproofing compound by brush or roller at a spread rate of 1litre/m².

Step 2 Embed the Sika® RainTite membrane into the base coat while it is still wet. Ensure that the Sika® RainTite membrane is thoroughly embedded and smooth out all air pockets and creases. Overlaps of adjacent Sika® RainTite membrane must be a minimum of 50 mm.

Step 3 Immediately apply a second coat of Sika® RainTite waterproofing compound at a spread rate of 0.6 litre/m² while the base coat is still wet to fully saturate the Sika® RainTite memebrane from both sides.

Step 4 When touch-dry, apply a final top coat at a spread rate of 0.5 litre/m² to complete the application. Protect from rain until dry.

Remove uncured surface Sika® RainTite with water. Cured material can only be removed mechanically.