Product Data Sheet Safety Data Sheet Show all documents

EVERBUILD CEMSTRIP®

Environmentally friendly, concentrated cement remover

EVERBUILD CEMSTRIP® is a new type of cement, concrete and mortar stain remover that provides a more environmentally-friendly and safer alternative to conventional hydrochloric acid based cement removers. EVERBUILD CEMSTRIP® will also remove salts and efflorescence from the surface of mineral substrates and is a very effective general cleaner for removing ingrained dirt, grease and stains from paths and patios. EVERBUILD CEMSTRIP® is a highly concentrated formula that can be diluted by up to 10 times with water to suit a variety of applications. Unlike hydrochloric acid based products EVERBUILD CEMSTRIP® can be safely used on most metal surfaces such as tools, cement mixers and other building equipment.

  • Available in bottles or as a ready to use spray.
  • Water clean up.
  • Economical, makes up to 10 times the volume of the bottle when diluted.
Product Data Sheet Safety Data Sheet Show all documents

Usage

  • Removes cement, mortar and concrete on most mineral surfaces such as paths, patios and walls.
  • Cleaning tools, cement mixers and other building equipment.

Advantages

  • Available in bottles or as a ready to use spray.
  • Water clean up.
  • Economical, makes up to 10 times the volume of the bottle when diluted.

Packaging

1ltr and 5ltr plastic containers, 1ltr sprayable container

Colour

Thin green/yellow liquid

Product Details

Product Information

Shelf Life

24 months form date of manufacture.

Storage Conditions

KEEP AWAY FROM CHILDREN. Store away from alkaline products and bleach at moderate temps.

Density

1.09g/cm³ at 20°C

pH-Value

1.4-1.7

Application

Consumption

Yield

Approx. 10m2 per litre depending on porosity of substrate.
Application steps

MIXING

9 parts water to 1 part EVERBUILD CEMSTRIP® -  Cleaning general stains and ingrained dirt from paths, patios and horizontal surfaces.

2 parts water to 1 part EVERBUILD CEMSTRIP® – Cleaning light mortar stains from paths, patios, walls or vertical surfaces.

1 part water to 1 part EVERBUILD CEMSTRIP® – Cleaning heavy mortar stains from walls or vertical surfaces.

Neat – Cleaning tools, cement mixers and other building equipment.

SUBSTRATE PREPARATION

When cleaning path, patios, cement stains etc. from surfaces always thoroughly wet surfaces prior to application. Do not apply to a dry surface. Always test a small inconspicuous area prior to full application. When cleaning tools and equipment, pre-wetting is not necessary.

APPLICATION

General Cleaning:

Moisten surfaces with water and apply EVERBUILD CEMSTRIP® with brush or low pressure spray (avoiding mist formation) from top of area down to bottom. Leave for 5-10 mins then scrub/wash off with a hose, brush or power washer until the surface is clean. Never allow the product to dry on surfaces. Where a second application is necessary, follow the procedure as above.

Cleaning tools/equipment:

EVERBUILD CEMSTRIP® will remove fresh cured cement and wet or semi-cured cement from tools. Spray onto item in question. Leave for 15 mins to act, (light stains) or up to 3 hours for heavy contamination.  Wash off the product with clean water. Utilising a scourer will assist removal of stubborn stains. Use a hot power wash to assist removal of staining from mixing equipment. After removal, always spray tools with Everbuild XT44 Maintenance Spray (or any other proprietary maintenance spray) to prevent further corrosion/rust.

Documents