Product Data Sheet Show all documents

Sika® Antisol®-107

(former MKure 107)

Water based concrete curing compound, white pigmented for solar reflectance

Sika® Antisol®-107 incorporates a white pigment which at recommended coverage rates gives a daylight reflectance value of 60-80%. This permits a high curing efficiency to be maintained even in conditions of intense ambient light.
Sika® Antisol®-107 is a solvent free, membrane forming wax emulsion, suitable for spray application to freshly poured concrete.
The resultant film retains sufficient moisture in the concrete to ensure full hydration of the cement, essential for optimum strength development. Membrane cured concrete is typically harder and exhibits a dust free surface with a reduced incidence of drying shrinkage cracks.  

  • Eliminates the need for water.
  • Single application.
  • Promotes a harder dust free surface.
  • Cured film is clear and water repellent.
  • Reduces drying shrinkage.
  • High curing efficiency.
  • Reduced labour costs.
  • Water based.
  • Solar reflective.
Product Data Sheet Show all documents

Usage

As a more effective and economical alternative to hessian and water and polythene curing regimes. Suitable for use on all concrete surfaces.

Advantages

  • Eliminates the need for water.
  • Single application.
  • Promotes a harder dust free surface.
  • Cured film is clear and water repellent.
  • Reduces drying shrinkage.
  • High curing efficiency.
  • Reduced labour costs.
  • Water based.
  • Solar reflective.

Packaging

Sika® Antisol®-107 is available in 20 litre or 210 litre drums.

Colour

White liquid

Finish appearance - White solar reflective, tack free, water repellent

Product Details

Sustainability / Certifications / Approvals

APPROVALS / STANDARDS

ASTM C309 Type 2 Class A

 

Water retention (ASTM C309) - Pass
Drying time (ASTM C309) - 3 hours
Product Information

Shelf Life

12 months when stored correctly and in an unopened container.

Storage Conditions

Store under cover, out of direct sunlight and protect from extremes of temperature.


Failure to comply with the recommended storage conditions may result in premature deterioration of the product or packaging. For specific storage advice consult the Sika Technical Services Department.

 

Density

0.970 -1.010

pH-Value

7.0 – 10.0

Application

Application Information

Dispensing

DIRECTIONS FOR USE
The compound should be spray applied as evenly as possible on to the freshly placed concrete.


For horizontal surfaces Sika® Antisol®-107 should be applied as soon as the initial surface sheen has disappeared from the concrete surface. In the case of formed concrete, the Sika® Antisol®-107 should be applied immediately on removal of the formwork. To assist breakdown of the Sika® Antisol®-107 film on vertical and formed surfaces, it is essential to dampen down the concrete with clean water prior to application.
Consumption

Consumption

COVERAGE
The recommended rate of application is 5-6 square metres per litre.

This corresponds to that at which Sika® Antisol®-107 has been tested, and at which it attains the claimed degree of curing efficiency. In favourable conditions such as shaded interior surfaces, adequate curing can be achieved with extended coverage rates.

Documents